Home / Guides & FAQ

Guides & FAQ

Touch foil questions, answered.

What touch foil works with, how to choose one and how to keep it working well. Can’t find your answer? Call 888-631-5880.

Choosing

Choosing a touch foil

What is touch foil?

Touch foil is a thin, clear film with a built-in touch sensor. Applied to the inside of glass or acrylic, it makes the glass work like a touch screen. Put a display or a projection behind the glass and connect the foil to the computer with one USB cable.

Which surfaces does it work through?

Glass, acrylic and other non-conductive materials. Every model works through up to 10 mm; Pro Touch works through up to 12 mm, including laminated double glass with no air gap. The glass must not contain metal, and thinner glass gives better touch.

What is a touch point?

Each finger touching the glass is one touch point. A 10-point foil tracks up to ten fingers at once, which covers pinch and zoom for one or two people. For groups or large screens, Pro Touch tracks 20 or 40 points.

Can I see the foil?

Our wire foils are almost completely transparent; the fine grid is hard to notice at normal viewing distance but can be seen up close. If no grid can show, choose ProFoil Clear, which has no visible wires.

What sizes are available?

From 2″ (ProFoil Clear) and 10.1″ (wire foils) up to 100″ as standard, custom sizes up to 1.4 × 4.5 m, and round foils up to 280 cm. See sizes and specs.

Does it work with a Mac?

Yes, with the Pro Touch 40 controller. Some macOS versions support only single touch rather than multi-touch, so tell us your Mac and macOS version. Windows, Android and Linux are supported across the range.

What comes in the box?

The touch foil, its controller board and a USB cable. ProFoil Clear is supplied already laminated on glass.

What is the warranty?

Three years on the foil and one year on the controller. ProFoil touch foils are CE and RoHS compliant.

How much does touch foil cost?

Price depends on the model, size, quantity and any custom cut. Ask for a quote with your glass and screen sizes.

Installing

Installation and troubleshooting

Can I install it myself?

Yes. Wire foils are applied wet like window film: clean the glass, peel the liner while spraying water, position, squeegee and let it dry 24–48 hours. Full steps are on How it works. ProFoil Clear arrives laminated on glass.

Can I move a foil to different glass later?

No. Each foil is a one-time install. Test it with its controller before you apply it.

There is a bubble under the foil.

Near the edge, lift the area while spraying water and lay it down again. Near the middle, prick the bubble with a fine needle, away from the wires, and slowly press the air out.

Touch is reversed left-to-right or up-and-down.

The touch direction can be flipped in the controller settings. Call us and we will walk you through it.

Lines break or the touch jumps.

Breaks usually mean sensitivity is too low; jumps usually mean it is too high or there is interference. Check grounding and cable routing first, then adjust sensitivity in the controller tool. If the foil was hand-installed, check for water left in a corner.

Touch stops working after a few hours.

If unplugging and replugging the USB brings it back, it is interference: ground the system and discharge static. If it still does not work, restart the computer; the power supply may be the cause.

How do I avoid interference?

Use a grounded socket and a good power supply, ground the controller to the frame, keep the USB cable away from power and display cables, keep metal 3 mm from the foil, and keep the controller 5 cm from card readers and other radio transmitters.

Still have a question?

Call or email and a real person will answer.